Kingston KVR1066D3N7/2G 2GB DDR3-1066 CL7 SDRAM

The Kingston 2GB DDR3-1066 CL7 SDRAM (Synchronous DRAM) Memory module is based on sixteen 128M x 8-Bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. 533MHz fCK for 1066Mb/sec/pin Programmable CAS Latency: 5, 6, 7, 8, 9, 10 Posted CAS Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency (CWL) = 7(DDR3-1066) Burst Length: 8 (Interleave without any limit, sequential with starting address ?000? only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe Internal (self) calibration: Internal self-calibration through ZQ pin (RZQ: 240 ohm) On Die Termination using ODT pin Average Refresh Period 7.8us at lower then TCASE 85?C, 3.9us at 85?C 1066Mbps CL7 doesn?t have backward compatibility with 800Mbps CL5 PCB: Height 1.180? (30.00mm), double sided component CL (IDD) 7 cycles Row Cycle Time (tRCmin) 50.63ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 110ns Row Active Time (tRASmin) 37.5ns (min.)